got ethical husbandry?

Apex Fusion Club

My skimmer is a Vertex Alpha 170 which uses an AC pump. So I just have it running 24/7. I've thought about just plugging it into the wall since I've not used any of the apex programming with it.
 
My skimmer is a Vertex Alpha 170 which uses an AC pump. So I just have it running 24/7. I've thought about just plugging it into the wall since I've not used any of the apex programming with it.
I want my skimmer to turn off when my return pump turns off and during feed mode


Sent from my iPhone using Tapatalk
 
You think this settings are ok?

Fallback ON
Set ON
If outlet ReturnMain_2 = OFF Then OFF
If FeedA 000 The OFF
Defer 001:00 Then ON


Sent from my iPhone using Tapatalk
Yes, should be fine.
I do it a bit differently: My "Feed" mode is set to last an hour. So no defer needed.
 
It should be. On the screen that lists all the apex's next to yours there's an arrow instead of a gear. Click it and follow the instructions.
 
It should be. On the screen that lists all the apex's next to yours there's an arrow instead of a gear. Click it and follow the instructions.
Gave up. Couldn't update
3fc5f3f55e5571f02a225b90137304ab.jpg



Sent from my iPhone using Tapatalk
 
I had issues also. Not with firmware update, but with web interface.
Sounds different though.

From the forums, this worked for me:
1) Power off Apex
2) Run update
It will fail. But do not close tool.
3) Power on Apex, and wait for it to boot.
Hit update on the tool again.

(Check that IP address did not change on reboot though)
 
Back
Top