Finally got an RODI unit set up. Since I've committed to a small tank for the foreseeable future, I picked up an AWI Mighty Mite... Only 50GPD but should work for now. The mentioned wasteroduct (I think) was 4:1...But I'm getting almost 1:1. There's a flow restrictor that controls the waste output line and I have that so there's a slow but steady stream coming out, just enough to keep it continuous. This produces a slow but steady stream of about the same amount flowing from the product line. Water faucet is barely turned on but I'm getting 0 TDS in the product water... Is this as good as it seems or am I wearing out the membrane, bypassing something etc??? Unit is this one.
TDS goes from 95--> 0 at about a gallon an hour.
Tap - 95
Product - 0
Waste - 155
..Seems like it's working properly?
Thanks for the help
TDS goes from 95--> 0 at about a gallon an hour.
Tap - 95
Product - 0
Waste - 155
..Seems like it's working properly?
Thanks for the help