Jestersix

Ashburn's 187g endgame tank

Update since the tank leak.

fixed the frag tank with corner re-enforcement that they wont move, and glue the corner, also added a triangle piece to tighten the corner. so far it hasnt been leaking.

Here comes another disaster, i managed to knock over my co2 tank ( smaller one that i was going to finish up the rest co2 and it's wobbly ) over and hit the calcium reactor acrylic cylinder body, and crack developed starting from the hole at the bottom, assuming it's SOL and not repairable. but thank god i still have my old reactor, will have to refund the buyer $$ and do leak test today.

go some new SPS the other day and all of them are looking really good

14d5a9850c4889ea607d0aab971a3233.jpg
55b5e497d8851c378cd49816dcc7e19b.jpg
eed3e562485ebb56f52d878a6b71472e.jpg
67e00da160434ac7aa02bbfe80920593.jpg
73ea1d613adb9e598940b641cc72c00c.jpg


I notice the colors are off, I guess I will have to use a real camera and correct light setting for photo shoot next time
 
Thanks to apex, it warned me temperature drop and one of my 300w heater broke, had to throw in 2 100w heater for now until I get another high wattage heater in place.


Sent from my iPhone using Tapatalk Pro
 
Isn't that a shame. I would just get a heating element and a ranco controller to use with apex for double redundancy. Those heaters with built in thermostat break a lot.


Sent from my iPhone using Tapatalk Pro
 
got new test kit refill in.

i know im not supposed to case the #... but here it is.
ph 8.2
and the rest to come later tonight
 
That's aweful high alk...on purpose?
i had a carx accident a while back where i did not see how much water was dumping back into the sump, and my tank had plunged ph way down to 5 or something, so i had to raise the ph back to 7 by adding the alk part from a 2part dosing. and lowering the alk little by little since then with water changes. thank god my tank has high nutrients and i haven't had any sps burns.
 
Back
Top