Krak256's latest activity

To celebrate and give back to the community, we’re launching two special offers: Offer 1: 20% off sitewide with code BARSponsor20(valid...

After the 10 minute mark Jake gets into the co2 effluent off gasing/dilution which can lower your PH. Some tanks pH drop every night a...

Fragging all toadstools and leathers is pretty much the same process. Remove and put in a separate container. Use sharp scissors and...

I’m in Sunnyvale and would be open depending on dates

@iani i really like it.

Well since you are controlling co2 with pH increase the pH setting on the controller and change the effluent rate based on your aquarium...

Are you off gassing the effluent ? Pushing or pulling with the Kamoer? That is a debatable subject Geo's Reef recommends pushing with a...

What do you mean by gassing the effluent? The kamoer is pushing water from the sump into the reactor.

That makes sense. I increased the ph to 6.7 which should lower the dkh of the effluent

Thanks. What is your recommendation?

Sorry, it may have not been clear in post. I wasn't expecting it to be 25 dkh but I read somewhere that I should be targeting 25 dkh...

What makes you think that? It's a brand new probe and was just calibrated.

I haven’t run a calcium reactor in 25 years. But I have had a conversation with Sam Parker ( Parker’s reefs) about the air bubbles in...

I recently switched over from dosing 2 part to a calcium reactor and need a bit of help. The setup is a Kamoer STP2, Carbon Doser, and...

Derek, if you can’t snag this one I have a colony that looks similar. Happy to give you a frag