RandyC's latest activity

Specioas are evil mofos. I've been working on this one for a month or so. Already bleached it a little, but at least it's still alive...

This is a timeline of a mariculture piece I got from Clearwater about 5 months back. Post in thread 'Randy’s Flock o' Reef Tanks'...

Polycarbonate lid made from two pieces. If you want to get fancy, you could add a handle and use some weld-on to attach. I dremeled a...

Just find polycarbonate (do not used cast acrylic) from the scrap bin and cut to fit. Probably will cost you less than $5.

New project. The wrasses need more room to swim so they are getting an upgrade. Aluminum extrusion stand is almost ready! The stand's...

A week in copper is not long enough to get rid of velvet or ich. I suggest you visit humble fish to understand the QT procedures for...

Standard rectangle razor blade and 50lb test fishing line.

Oh and here's why unions are so important in large tank or multi tank setups. If I had to replace that faulty bulkhead (the one at the...

150 Gallon Tank (Day 138) Some enabler mentioned a good deal on a tank to me and not surprisingly, I went and got it. I ended up adding...

While not CPEX true union ball valves, these have served me well over the years at a fraction of the cost. https://a.co/d/2a03BER

If you're going threaded into the bulkhead, make sure you use pipe dope/thread sealant and not Teflon tape. In my experience, Teflon...

Then even more reason to have them higher. You can't move that tank easily because you can't set it down on the bottom of the tank...

Those unions are going to be a pain in the ass to service, if even at all possible. If it was me, I would have put the union closer to...