Neptune Aquatics

3D print plugs

Is it cost effective? I mean s plug is like 20cent :)


Sent from my iPhone using Tapatalk Pro
cheapest plugs are 11 for $17

Abs filament 1kg is $22

I’m sure you can print more than 200 plugs out of that.


Sent from my iPhone using Tapatalk Pro
 
What about the good ‘OL method of making molds in wood and making your own plug/disks that way?

Problem with that is you can only mix limited numbers at once and making 100 takes forever. But I did though about that. Then again, it’s messy and longer process than just printing it out.


Sent from my iPhone using Tapatalk Pro
 
Ahhh. I mean, if I had a printer already, I would go that route. But since I don’t, if I want to make disks, I will go the mold route
 
I had the experience of having plastic frag plugs; I believe they were ABS, not sure on that but they suck; are very light in weight and tend to be blown knocked off by critters...
I had several bags and gave all of them away.
 
I had the experience of having plastic frag plugs; I believe they were ABS, not sure on that but they suck; are very light in weight and tend to be blown knocked off by critters...
I had several bags and gave all of them away.

The new ones clips on the eggcrat instead of slot in.


Sent from my iPhone using Tapatalk Pro
 
I see plenty of options for 15-20 cent plugs when bought in bulk, like 1000 plugs. And would be superior calcium carbonate or ceramic rather than plastic.

I could see making them if you ran out and needed a couple in a pinch and had a printer already.
 
I see plenty of options for 15-20 cent plugs when bought in bulk, like 1000 plugs. And would be superior calcium carbonate or ceramic rather than plastic.

I could see making them if you ran out and needed a couple in a pinch and had a printer already.
Where from? Let's do a group buy!
 
I don’t any special inside info, lol. Just google 1000 frag plugs or bulk frag plugs. Amazon, EBay, etc. Looks like the cheapest ones are ceramic. Personally I don’t mind paying a little more for more normal quantities from retailers I’d rather support.

Anyway I’m just pointing out that while 3D printing is admittedly cool, this doesn’t seem like a particularly cost-effective approach to scale up. And I don’t like plastic frag plugs.
 
While 3d print is cool it takes so long and power you don't calculate the power use to print it.


Sent from my iPhone using Tapatalk Pro
 
Back
Top