RandyC's latest activity

I gotta be blunt. I get it, it's your DBTC frag and your rules, but with rules this strict, you're probably better off finding a select...

That's a buttload of frags! You're going to have to frag every other day soon to prevent them from attacking each other. ;)

Crazy that you mentioned this while I was ordering. I just went through a whole ordeal where FedEx delayed 2 priority overnight...

Not ideal, but you can either crop the image a little bit to decrease the file size or change the settings to capture in 12MP vs 24MP.

Where was the silicon used? Silicon's ability to resist ozone really depends on the environment. Ozone typically will not have an affect...

Appropriately sized UV sterilizer. Black out for 3-5 days (including fuge). If nitrates and phosphates are zero, bring them up to...

Did it look they were rotating/rolling over on an axis? If so, it's ostreopsis.

Perhaps KZ have created their GAC in a special manner that they recommend hot water flushing before use. However, that's the first I've...

Is there a reason you're rinsing with hot water? Any source material that says you should be doing this? GAC is really only for use with...

Your gasket already looks like it's may have an imperfection in it. It's too hard to tell from the angle of the pic, but if the chip...

Also, since the tank is away from the wall, if you just use the gasket that came with the bulkhead and not use that gasket sheet, you...

Put the gasket up next to the chip and take a picture for scale. Does the chip cover extend more than 50% the width of the gasket?

Looks like a 3/8" (maybe 1/2") push connect. Get 3/8" stem to 1/4" push adapter. Double check size before buying https://a.co/d/1NyA682

Some overflows (especially slim models) require that to be done to fit the standpipe. Here's a pic of my IM25 with a Marine Modular...

You can cut the bulkhead as long as the bulkhead extends 1/8-1/4" past the nut after it's been tightened.