Controller board mounting help
- Thread starter Darkxerox
- Start date
I’m confused. Are you looking for a fancy screw or are you asking how to just attach the board to the aquarium stand ?
DaddyHook
Supporting Member
Probably need a “post screw” in aluminum or stainless. And “fender washers” to accommodate the larger diameter screw.
Just the type of screws to securely mount into the board. The board and power centers are already secured to the stand, I just need to figure out the ideal hardware to mount the peripherals like Vortech drivers, pump controllers etc. into/onto the board.
@DaddyHook I'll look into those today at the hardware store. Thanks!
Coral reefer
Past President
Check out multiboard for mounting it’s pretty cool. Can avoid screws and easily move stuff around
Yeah not much clearance behind the door though, 3” tops which is just enough to fit the controllers
I've got full access to both sides, so I figured screws with nuts would be the best to replace or move things later?
If I’m doing something special. I order from here. They have a lot of stuff
www.mcmaster.com
If you’re not sure. Silicone it or industrial Velcro.
McMaster-Carr
McMaster-Carr is the complete source for your plant with over 595,000 products. 98% of products ordered ship from stock and deliver same or next day.
If you’re not sure. Silicone it or industrial Velcro.