PIF: trident printed form factor (edit)

[L/B Block]

Two items for supporting members only:
1) Trident alt form factor. Funny enough the original fits better in my sump. Note-there is one piece that needs to be 3D reprinted (the lime looking thing (@ashburn2k ) or another can print it out.

You can use a tab of glue to also hold the curvette in place but I found I didn’t need to.
It does need a cleaning as well.

2nd item- co2 scrubber cap for an octo reef skimmer. There are many that this will acccomodate. If you look it up online it will give you all the protein skimmers it works with. Comes with hose.

Pick up Oakland. I can drop items at high tide as well.

 

[FreahSaltyGuy]

Hello I will take the CO2 scrubber please. PM sent also. Thank you for sharing.

 

[L/B Block]

Yours

 

[FreahSaltyGuy]

Sent PM I'm going to pass on it. I noticed it was not made for my 250. But appreciate it.

 

[L/B Block]

Back on the market!

 

[wazzupmac]

I’d take the CO2 scrubber lid - I gotta regal 150 that it would fit perfectly

 

[L/B Block]

I’d take the CO2 scrubber lid - I gotta regal 150 that it would fit perfectly

You got it. Where are you?

 

[wazzupmac]

I’m in Castro Valley - I can easily pick up from Kenny if it wouldn’t inconvenience him or meet you

 

[L/B Block]

I can get it over there. I am about a mile away.
He is not open though until Wednesday.

 

[Alexander1312]

You are generous, but I am surprised you give away the CO2 lid. This is one of the few reasons not to switch to a Deltec skimmer, as I have not seen them selling these.

 

[L/B Block]

@Alexander1312 -BRS gave me the wrong info when I bought it and it actually does not fit my skimmer. They simply let me keep it and refunded the money. Figured someone else can put it to good use

 

[L/B Block]

Bump. Any last takers or it gets put in the trash..