I've been having really weird alk issues in my saltwater mix. I'm testing it after mixing, and it has been lower then expected, let's say 8 dkh. Then I leave it for a couple days, and I'll test it again, and it'll be like 6.8 dkh.
I've added some soda ash alk liquid, diluting it even more with RO and then slowly pouring it into where the mixing pump sprays out, trying to ensure I don't precipitate. I've tested afterwards and seen a reading above 9 because I was off on my estimate (targeting 8.5). I then test it a day or two later and it's in the 7. Days later I'm at 6.7.
Red Sea black bag. pH seems about right. Salinity in the 34.5ppt range. In a brute garbage can with lid on. I haven't dumped the can recently, but I don't think I see any major precipitate on the bottom. Mixing pump is a little return pump from a fluval and a little powerhead.
Not heated. I'm pretty sure I've seen this happen both with and without the pump having ran.
Garage does get warm.
This seems very weird, I'm not sure what's going on, and it's annoying to feel I need to test my mixing water every time I want to use it.
Tested with a Hanna and my diy alk tester. Both give good readings on other setups, and I can see the numbers high after adding alk so a reading issue can't explain it.
I've added some soda ash alk liquid, diluting it even more with RO and then slowly pouring it into where the mixing pump sprays out, trying to ensure I don't precipitate. I've tested afterwards and seen a reading above 9 because I was off on my estimate (targeting 8.5). I then test it a day or two later and it's in the 7. Days later I'm at 6.7.
Red Sea black bag. pH seems about right. Salinity in the 34.5ppt range. In a brute garbage can with lid on. I haven't dumped the can recently, but I don't think I see any major precipitate on the bottom. Mixing pump is a little return pump from a fluval and a little powerhead.
Not heated. I'm pretty sure I've seen this happen both with and without the pump having ran.
Garage does get warm.
This seems very weird, I'm not sure what's going on, and it's annoying to feel I need to test my mixing water every time I want to use it.
Tested with a Hanna and my diy alk tester. Both give good readings on other setups, and I can see the numbers high after adding alk so a reading issue can't explain it.