sfsuphysics
Supporting Member
That helps from the falling glass hitting the bottom pane, which I did see in the picture. I was talking about possible chipping around the hole part.Or lay a towel at the bottom
Sent from my iPhone using Tapatalk Pro
That helps from the falling glass hitting the bottom pane, which I did see in the picture. I was talking about possible chipping around the hole part.Or lay a towel at the bottom
Sent from my iPhone using Tapatalk Pro
Well ya did a fine job thenI actually did tape it =). The tape was clear so it is kinda hard to see. Thanks!
When you go to mix your salt water it’s ok to do it in the tank but I like to fill the tank only about 90% with water and then add the salt. Definitely don’t put the salt in first and then add the water. You can get precipitation because it’s too concentrated. Also, I do 90% full because I try to sneak up on the salinity but sometimes I’ll go over and if the tank is already full I can’t add more water to dilute it.Finally got the sump in and in the process of making rodi. Unfortunately it is a long process to make enough water for this much volume. I plan to mix the salt in the tank and wondering if I should take the dry rock and marine pure block out when putting in the salt. Plan to add some prime as well to the tank bc I'm unsure if the rodi is filtering out the chloramine. Finally got my hands on some fritz turbo 900 just waiting on the ammonia to get in to start the cycle.
Also wondering if the 10lbs dry rock and marine pure block is enough. Only going to be housing a pair of clowns and used as a frag tank.
When you go to mix your salt water it’s ok to do it in the tank but I like to fill the tank only about 90% with water and then add the salt. Definitely don’t put the salt in first and then add the water. You can get precipitation because it’s too concentrated. Also, I do 90% full because I try to sneak up on the salinity but sometimes I’ll go over and if the tank is already full I can’t add more water to dilute it.
Do you have a pressure gauge on your rodi?
I wouldn't bother with a skimmer on the system. Such a low bio load. I think a dosing pump will be of huge benefit.






