PizzaOven
Supporting Member
A while back, my Kamoer doser started leaking and dumped kalk all over my controller cabinet (yay). The tubing inside the head unit had ruptured and started to leak. This may have actually been my fault, because when I replaced the tubing last time, the OD seemed slightly larger than the old tubing. I'm guessing this put more pressure on the tubing causing it to fail after just a few months. When that happened I moved the Kalk to an empty channel on my Red Sea doser. This wasn't ideal, this unit isn't designed to dose large quantities so frequently.
Today I fixed the Kamoer and replaced all of the tubing in the Red Sea. I've had the same tubing in the Red Sea unit for years now and figure it's time to replace to avoid failure.
I found what I think is the right size for the Kamoer (2mm ID x 4mm OD):
I bought 4x replacement tubing from Red Sea, to make sure the size is right:
Recalibrated both units. Hopefully no more leaks...
I've also recently noticed some heads of frogspawn losing color. I'm trying to target feed them to see if they recover:
Full tank shot:
Today I fixed the Kamoer and replaced all of the tubing in the Red Sea. I've had the same tubing in the Red Sea unit for years now and figure it's time to replace to avoid failure.
I found what I think is the right size for the Kamoer (2mm ID x 4mm OD):
I bought 4x replacement tubing from Red Sea, to make sure the size is right:
Recalibrated both units. Hopefully no more leaks...
I've also recently noticed some heads of frogspawn losing color. I'm trying to target feed them to see if they recover:
Full tank shot: