Reef nutrition

Glass fabrication, Where?

xcaret

xcaret

Guest
BARcard
So I have the idea; if the glass tank with the chip in the lower back would have to be taken apart to re-do the silicone, you guys think that a glass shop/fabricator would trim maybe a couple inches both side panels and the bottom piece? I mean, if the bottom is not tempered.
@Flagg37 and anyone else input is appreciated.
 
Depends how thick. The thicker it is the more likely it will be that they refuse because thick glass is difficult to break cleanly.
 
Nope, 12mm 1/2"
There are some places in Hayward that have a water jet and can finish edges; just wonder if they would do the work for a non-commercial person.
Sent an e-mail to one of them last night, just waiting for a reply.
 
You must log in or register to reply here.
Back
Top