Installing RODI unit on a water hammer

[finalphaze987]

Hey all..

I'm looking to relocate my RODI set up to my garage and use the washing machines feed asy source. When looking at the valve, it has a water hammer installed where I would tee it off.

Does anyone have any experiences with doing the same? Are there any issues I should be weary of? Not sure if I should be expecting too much pressure vs not enough.

The unit ill be installing is the BRS 7 stage to give an idea, if that helps..

 

[Srt4eric]

Problem solved

 

[Srt4eric]

That hammer arrestor is part of that bib. Just get a splitter like pictured above and tee off of it.

 

[finalphaze987]

That hammer arrestor is part of that bib. Just get a splitter like pictured above and tee off of it.

Sweet! All the parts I have found are plastic...good to know they make these!

Thank you