Kessil

Need Some Drain & Sump Wisdom

Well, this tank has been humming along nicely under the primary care from @a.little.hypertonic

I'm still trying to get the skimmer dialed in. It tends to be sensitive and skim very wet. If I dial it back, then it makes lots of foam that doesn't tend to break down to liquid. So still learning and making small adjustments.

Here's a few pics to share of inhabitants.
1000000551.jpg

Thanks to whomever brought the plastic witch hats to the swap. The atomic broccoli was stolen earlier today.
1000000546.jpg


1000000548.jpg
 
What skimmer again? Could be too big for the bio load
Or sump water level is too high.
Thanks for the responses gents.

I picked up a used Reef Rythm RR-150 from @Srt4eric

I have messed with multiple pump speed settings and also the air intake. It's definitely closer than I was a couple weeks ago. I currently can go a couple days before we empty the cup. I'll get a picture of what it looks like before we empty. A couple times it was overflowing with dense bubbles that wouldn't break, filling the cup.

I have the skimmer on a stand because the default water level was too high. With the stand, the skimmer is now slightly above the recommended manufacturer height. I did message Reef Breeders and they said going lower on the skimmer is fine. So I haven't made any adjustments to the stand. Just trying to dial it with pump speed and air intake.
 
Thanks for the responses gents.

I picked up a used Reef Rythm RR-150 from @Srt4eric

I have messed with multiple pump speed settings and also the air intake. It's definitely closer than I was a couple weeks ago. I currently can go a couple days before we empty the cup. I'll get a picture of what it looks like before we empty. A couple times it was overflowing with dense bubbles that wouldn't break, filling the cup.

I have the skimmer on a stand because the default water level was too high. With the stand, the skimmer is now slightly above the recommended manufacturer height. I did message Reef Breeders and they said going lower on the skimmer is fine. So I haven't made any adjustments to the stand. Just trying to dial it with pump speed and air intake.
I never had to mess with the pump speed. I kept it on 1 and just messed with the air.
 
Back
Top