High Tide Aquatics

Thesassyindian's 13.5 gallon m̶o̶n̶e̶y̶ ̶p̶i̶t̶ nano mixed reef

If that's not a HD version Hydra 26 you can switch the LED pucks out to Luxdium ones vs buying a new light. If the rest of the internals are OK.
 
And boom! Same damn failure mode manifests again. Come on Aqua Illumination!!
1666935303946.png


I've previously repaired this exact capacitor on two separate Hydra26's!

This time around, the capacitor dug deep - ripped a couple of layers of traces and FR4 underneath.
1666935417936.png


Will take this back up at a later date and attempt to repair the light once again - Now it is a matter of principal... Haha :)
 
After a tank crash scare last week, I finally started taking the first of two remaining steps towards automation.
Set up the FMM/ATK v2 with a DIY reservoir.

Found these 5.8qt OXO Pop container at Target for $20 and decided to use that as a reservoir to save some $$$. (Why are ATO reservoirs so expensive?)

1667414089706.png


Drilled two holes through the lid for the pump power and water tube.

1667414567742.png


Next, for the siphon break, I printed a small magnetic bracket to keep it in place above the water line.
1667414826154.png


1667414853451.png


1667414956276.png


1667415154158.png


FMM Program:
1667415004073.png
 
You must log in or register to reply here.
Back
Top