Thanks guys, as for my PH, I used to have issues with my PH when I had a PM and geo reactor, but since I set up the new tank with the AquaC, for some reason, I have not had a problem. I can not say that the reactor is the solution for sure, but I'm not complaining either

My effluent is located right in the path of on my my drains into my sump. I do not have a sceond chamber or use a cup or any other device; heck I don't even use a PH controller to monitor the reagulator, just the old school method of the bubble count vs. effluent.
I have noticed that as the pump from the skimmer is placing more air into the water, my PH is slightly lower. This morning @ 5:05am it is 8.09. When it is this low, I just take a spoonful of Seachen "ph to 8.3" and it helps boost the system.
Thanks again. Hope this helps/