High Tide Aquatics

My 210 restart.

Finally got it cleaned up. Can't wait to begin.

a8608501ad1119c0f23c6d94c2b8d42c.jpg



Sent from my iPhone using Tapatalk Pro
 
Well ill be damn this might be the cause of the issues in my tank. Frail wiring on one of my tunze stream 3.


Sent from my iPhone using Tapatalk Pro
 
3fd678b1a35ca7f75a207da17cd218e2.jpg


Seems like this is the cause of my issue as the fishes that went into other tanks while I reset thetank started to get better.


With that said v3.0 started today as I add water and run with rodi water for a week before adding salt.


7bdfaa28a070ce600a077435566fe74c.jpg



Sent from my iPhone using Tapatalk Pro
 
Without measuring, you should not assume those wires are actually causing current leakage.
The inner insulation can work just fine by itself.
Of course - it is bad - and it should be replaced.
 
rygh said:
Without measuring, you should not assume those wires are actually causing current leakage.
The inner insulation can work just fine by itself.
Of course - it is bad - and it should be replaced.
Click to expand...
Not necessarily the wires as you see, but the fact that water can get into the motor case, where that insulation at some point disappears so you effectively have stripped wires if there's not any water proofing between the grommet and the motor case (which usually there isn't because... cost *shrug*)
 
Well i cant say for sure but the tang that was really bad looking is healing well in the spare tank. The lost of fins started to heal.


Sent from my iPhone using Tapatalk Pro
 
I like the rock work pile on the left by the way.
Looks like some great hiding places for fish, good mounting for coral, and is fairly natural looking.
 
You must log in or register to reply here.
Back
Top